This tiny bipolar stepper has a 1.8° step angle and 600 g·cm of holding torque.
This is a nice, small, efficient stepper motor with good torque characteristics.
Motor Controller and Connection
The 3300 stepper motor connects to a bipolar motor controller such as the 1067 - PhidgetStepper Bipolar HC.
The following table shows how to connect the motor wires to the board connectors to produce a clockwise rotation in the stepper motor when increasing position. To wire for counter-clockwise rotation when increasing position, reverse the red and blue wires.
Note: Make sure to unplug the power cord from the motor controller before switching wires around.
|Connecting the motor directly to a power supply will destroy the motor and void the warranty. If you want to check your motor make sure it is connected to a constant current / chopper drive controller.|
|Motor Type||Bipolar Stepper|
|Manufacturer Part Number||28BYGH102|
|Step Accuracy||5 %|
|Holding Torque||600 g·cm|
|Rated Torque||520 g·cm|
|Maximum Speed (w/1063 Motor Controller)||600 RPM|
|Maximum Speed (w/1067 Motor Controller)||4688 RPM|
|Acceleration at Max Speed
(w/1067 Motor Controller)
|2E+06 1/16 steps/sec²|
|Recommended Voltage||12 V DC|
|Rated Current||670 mA|
|Coil Resistance||5.6 Ω|
|Shaft Diameter||5 mm|
|Mounting Plate Size||NEMA - 11|
|Number of Leads||4|
|Wire Length||300 mm|