This huge bipolar stepper with a rear shaft has a 1.8° step angle and 30 kg·cm of torque at low speeds.
When connected to a 1067 - PhidgetStepper Bipolar HC, the 3335 has a maximum speed of 200 RPM.
Motor Controller and Connection
The 3335 stepper motor connects to a bipolar motor controller such as the 1067 - PhidgetStepper Bipolar HC.
The following diagrams show two connection methods: series and parallel.
Series wiring will result in higher torque when the motor is stopped or at low speeds. Parallel wiring will provide better torque at higher speeds, but less torque overall. Since the current in parallel mode is split between two paths, the current rating is doubled.
When connecting motor wires to one another, you must solder or screw clamp them together rather than just twisting them together.
Note: Make sure to unplug the power cord from the motor controller before switching wires around.
The rear shaft of this motor can be equipped with the HKT22 Optical Encoder for applications where you need to keep track of the exact position, velocity, or acceleration of the motor.
|Motor Type||Bipolar Stepper|
|Manufacturer Part Number||86STH65-2808B|
|Step Accuracy||± 5 %|
|Holding Torque||34 kg·cm|
|Rated Torque||30 kg·cm|
|Maximum Speed (w/1067 Motor Controller)||200 RPM|
|Acceleration at Max Speed
(w/1067 Motor Controller)
|1E+06 1/16 steps/sec²|
|Recommended Voltage||30 V DC|
|Coil Resistance||1.4 Ω|
|Rated Current (Series Wiring)||2 A|
|Rated Current (Parallel Wiring)||4 A|
|Phase Inductance||3.9 mH|
|Shaft Diameter||12 mm|
|Rear Shaft Diameter||3.9 mm|
|Mounting Plate Size||NEMA - 34|
|Number of Leads||8|
|Wire Length||400 mm|
|Connecting the motor directly to a power supply will destroy the motor and void the warranty. If you want to check your motor make sure it is connected to a constant current / chopper drive controller.
This motor is large enough that the back EMF generated from stalling or changing directions could easily damage your motor controller. If you're planning on using this motor in high-speed or high-torque applications, feel free to contact us for advice.